MEASURING GUIDE FOR OUTDOOR ROLLER SHADES

This measuring guide is for Outdoor Roller Shades. Measuring for your new curtains couldn't be simpler. It's an easy way to save lots of money and takes just minutes. All you have to do is follow our easy, step-by-step guides.

CHOOSE A MOUNT TYPE:INSIDE CEILING MOUNT OR OUTSIDE WALL MOUNT

 

· Inside Ceiling Mount
    Window treatments are installed inside the window casing.


1. Measure Depth:
Measure at the depth within the frame where you’ll install the brackets. Minimum 3 inches depth is required for Inside Ceiling Mount. When install depth is less than 3 9/16 inches, the valance will extend beyond the window frame.


2. Measure Width:
Measure the openness width across the top, middle and bottom to make more accurate, take note of the smallest measurement to 1/16 inch.
*Considering wire guide security gap for installation, please leave at least extra 1" space on each side.

3. Measure Height:
Measure the height of window openness from top to sill across right, middle and left, take down the smallest one to 1/8 inch. Due to the bottom height of wire guide system, shades will have 3 5/16" clearance if installed on the ground.

*Note: Shades will have no deductions taken at the factory. They will be made according to your exact measurements.



· Outside Wall Mount
    Window treatments are installed outside the window casing.


1. Measure Depth:
Check the extended window casing depth, if there are handles or cranks, don't forget to take them into account.

2. Measure Width:
Measure the width of area you want to cover. Recommend adding 1-6 inches based on openness width to ensure light control and privacy.
*Considering wire guide security gap, please leave at least 1 inch space for installation on each side.

3. Measure Height:
Measure the desired height of area you want to cover and record the measurement. Due to the bottom height of wire guide system, shades will have 3 5/16 inches clearance if installed on the ground.

*Note: Shades will have no deductions taken at the factory. They will be made according to your exact measurements.

INSTALLATION GUIDE FOR OUTDOOR ROLLER SHADES

Please refer to the installation manual in your hand and the video guide at the bottom of the page, and start the installation after confirming the operation process. The seal of blind must be removed after installation is complete.

Please ensure that the position of installation is horizontal in advance. If it is not, you can use accessories such as shim to assist in adjustment.

The electric blinds can be controlled directly by the remote after installation is completed. If there is a need for smart device connection, you can further follow the corresponding instructions.